Joj
Member
- Joined
- Jan 10, 2022
- Member Type
- Student or Learner
- Native Language
- Arabic
- Home Country
- Lebanon
- Current Location
- France
Dear Mr. X,
We noticed that the area of the inclined roof is 8x8 rather than 6x8 as shown in the autocad drawing during our site visit yesterday. Could you please tell us what we should do in this additional area?
In the pdf drawing, you mentioned that we should use two grades of concrete: 40Mpa for module 1 and 25Mpa for module 2. Could you please tell us whether 25 MPa can be used for the two modules?
Can we use XX epoxy instead of Hilti epoxy? (Please see the attached data sheet for the XX epoxy, which is a British standard.)
We'll begin grinding tomorrow. Please see the following procedures for the next two weeks of sealing and casting in place concrete:
1- ...
2- ...
3- ...
Best regards,
We noticed that the area of the inclined roof is 8x8 rather than 6x8 as shown in the autocad drawing during our site visit yesterday. Could you please tell us what we should do in this additional area?
In the pdf drawing, you mentioned that we should use two grades of concrete: 40Mpa for module 1 and 25Mpa for module 2. Could you please tell us whether 25 MPa can be used for the two modules?
Can we use XX epoxy instead of Hilti epoxy? (Please see the attached data sheet for the XX epoxy, which is a British standard.)
We'll begin grinding tomorrow. Please see the following procedures for the next two weeks of sealing and casting in place concrete:
1- ...
2- ...
3- ...
Best regards,
Last edited: